Sizing Information:

Men’s Motorcycle Jackets and Vests:

Men's sizes are based upon standard shirt/jacket sizes, but do vary between manufacturers.  Please refer to the sizing charts below to determine the best fit for you..

NOTE: Some jacket sizes are listed as S, M, L, etc. while others are listed as Chest size. Depending on Jacket ordered, we will always send out the most accurate fit to the size specified

Ladies Motorcycle Jackets and Vests:

Women's Sizing Formula for Jackets & Vests: The chart below is based upon dress sizes.  For an accurate fit please refer to the chart below that provides accurate measurements for your size.

NOTE: All women's jackets and vests run one size smaller than standard U.S. sizing. For best fit, please order next larger size.

Leather Chaps:

To ensure proper fit, take the measurement around the top part of your leg (approximately 4” below the crotch) while wearing your jeans.  That will ensure that you will receive a great fitting and comfortable pair of chaps.  For a more relaxed fit, you may wish to add approximately 1” to your leg size when ordering your chaps. The waist is adjustable with belt in front and laces at the back.

Please note that Leather Chaps will stretch in the thigh with wear!

The standard inseam on our leather chaps is 34" with 8" available to cut off for sizing purposes. To adjust the length of your chaps, simply use a pair of sharp scissors and cut them to the desired length.

IMPORTANT: Please ensure the chaps fit before doing any cutting. Try them on with the footwear you will be wearing with the chaps before you cut them off!! Chaps that have been altered cannot be returned.

Hand Length Method:

Measure your dominant and from your wrist to the tip of your middle finger, as shown by the green line in the diagram above. This method is the same for both men and women.

Use the larger of the two measurements (Circumference or Length) to determine the proper size based upon the chart below.

Ring Sizing:

To determine the correct ring size, use the following method:

1. Take a piece of string or paper strip (no wider than 3/4”)
2. Wrap it around the base of the finger you wish to wear the ring on, then mark where the string / paper overlap.
3. Using a ruler, measure from the start to the marked point.
4. Use the chart below to determine correct size.